Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Three ISP conections,. How to configure?

We have a 2600 router with an internet conection with public IP and NAT to inside/outside access mailserver. We want to add another conection to inside access webserver and a DSL conection to navigate (via proxy).

I don't how to config this policy. Firewall has a default gateway to Cisco 2600, and Webserver and Mailserver have default gateway to Firewall.

Mailserver will use Internet 1, Webserver Internet 2 and LAN will use Internet 3.

Any suggestion??

Regards

Raul

This is the network :

..................->> Cisco 2600 --> Internet 1

LAN ---> Firewall | --> Internet 2

..................|

..........^.......->> ADSL router -> Internet 3

..........|

.........DMZ

.....------------

.....| |

Webserver MAilserver

1 REPLY

Re: Three ISP conections,. How to configure?

Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

86
Views
0
Helpful
1
Replies