Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Time-based ACL applys with delay

Dear Sir!

There are some confusion: when I use time-range for example:

time-range block-traffic

periodic daily 14:30 to 15:30

then time-based ACL apply not at 14:30 exactly, but with delay up to 60 seconds (i.e. 13s or 33s or 53s). Why?

What Cisco command can I use to adjust this delay to 0

Best regards,

Nick

1 REPLY
Community Member

Re: Time-based ACL applys with delay

I have found only this note for you on CCO:

The time range relies on the router's system clock. For this feature to work the way you intend, you need a reliable clock source. It is recommended that you use Network Time Protocol (NTP) to synchronize the router clock.

Regards.

93
Views
3
Helpful
1
Replies
CreatePlease to create content