Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

Time-Out error with Cat_OS 6.3 after reset timer

Hi,

I have upgraded some of my Cisco Cat. 4006 switches from 6.3 to 7.4.

After copying the image i configured the reset times for next day morning.

After this I am getting the following error message whenever I give any command on the switch...the switch is yet to take the new OS.

ptimeout : OUT OF TIMERS!!!...

I went ahead and rebooted 2 switches ....after which it came with the new OS.

With the new OS when i give Sh. Version...I get the NVRAM staictics as :

DRAM FLASH NVRAM

Module Total Used Free Total Used Free Total Used Free

------ ------- ------- ------- ------- ------- ------- ----- ----- -----

1 65536K 40641K 24895K 16384K 9416K 6968K 480K 426K 54K

Here is says only 54K as free...earlier it was giving 250K free...

Because of which I am getting contioue error on my Cisco Works...

Let me know whether this is OK....as I have to reboot another 8 more switches...

Let mw know..

Rds

Shrikant Aithal

1 REPLY
Bronze

Re: Time-Out error with Cat_OS 6.3 after reset timer

That would have been a cosmetic bug there. Did you try rebooting other switches? How did it go?

116
Views
0
Helpful
1
Replies