Two cisco bridge were connected via a ISDN link .I configed the DDR and dialer timeout to 1mins.However,I found the timer always counting down until it drop the line no matter whether you send the traffic across over it or not.
You need to configure a dialer-group under the DDR interface and a dialer-list globally, else it will timeout all the time at whatever value you gave - unless you use the persistant feature which was introduced in 12.2(4)T.
dialer-list 1 protocol ip permit
The above makes ALL IP traffic interesting. This traffic will bring up the ISDN/dialer interface and also reset the idle timer. You can configure dialer-list to reference an ACL to narrow down the traffic that would be interesting.
Thank you very much.But I forgot to mention that configuration was a one way DDR,I set the dialer list one side only.The question is how can I make the other side timeout work .Actually ,the calling side timeout is working well .
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.