Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

Token Ring Interface

Hello All,

I'm having a bit of troubles configuring a Token Ring Interface. I know TO is no longer supported or used.

I have a 2504 Router with 1 TO interface.

I have purchased a RJ45/DB9M modular Adapter for the TO.

How do I set the TO interface to use a standard RJ45 ethernet cable?

Can this be done?

Thanks in Advance.

juan

1 REPLY
Gold

Re: Token Ring Interface

RJ-45 to DB-9 Configuration

Connect the pins on the RJ-45 connector to the pins on the DB-9 connector as follows:

RJ-45 Pin

Wire Color

DB-9 Pin

Signal

3

Black (or Light Orange)

1

RCV+

4

Red (or Light Green)

5

XMIT-

5

Green (or Solid Green)

6

RCV-

6

Yellow (or Solid Orange)

9

XMIT+

Table 11 RJ-45 to DB-9 Configuration

The above configuration can be used whether the DB-9 connector is male or female, because the cables are “straight-through” with no cross-overs as found in a null modem.

101
Views
0
Helpful
1
Replies
CreatePlease to create content