Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Token Ring support on Cisco 3745

Is the NM-1E1R2W supported on the Cisco 3745? Using IOS 12.2(13)T8 the module does not seem to be recognised.

4 REPLIES

Re: Token Ring support on Cisco 3745

If you are using NM-1FE1R2W module, the supported IOS listed by Software Advisor are,

12.2(8)T1, 12.2(11)YT, 12.2(15)ZJ, 12.3(1), 12.3(2)T

New Member

Re: Token Ring support on Cisco 3745

Does this also apply to the NM-1E1R2W? Also we are using Call Manager v3.3 and SRST v3.0 so think we need 12.2(15)ZJ but this is a deferred release. What IOS do you suggest? Thanks

Re: Token Ring support on Cisco 3745

You can also try using 12.3 T to run SRST v3.0, if you have enough ram/flash. Looking at the other post, you wont be able to use the NM that you have on the 3745. You ll need a CCO login to see that link posted in the other post.

VIP Purple

Re: Token Ring support on Cisco 3745

Hello,

the NM-1E1R2W is not supported on the 3745. Check the following link for compatibility info:

http://www.cisco.com/en/US/partner/products/hw/modules/ps2797/products_tech_note09186a00800ad3cc.shtml

Regards,

Georg

114
Views
0
Helpful
4
Replies
CreatePlease login to create content