Cisco Support Community
Showing results for 
Search instead for 
Did you mean: 

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

token ring swith and SRB

Hi, I have some confusion regarding Token ring switch vlan and SRB, if a router token ring interface connecting to a token ring switch like 3900, and I'm going to do source route bridging.

interface token1

source-bridge 1003 1005 100 <-- is this correct? since 1003 is default trcrf and 1005 is default trbrf.

Thank you alot.


Re: token ring swith and SRB

Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center ( or speak with a TAC engineer. You can open a TAC case online at

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.