Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Token ring VLAN and Subnet

Hi,

On the token ring switch, the ip address is assigned to an TrBRF, so, am I correct to say that all rings(TrCRFs) under the same TrBRF will forms a subnet? what is the rule to design subnet/vlan for token ring source-route bridging?

Thanks.

1 REPLY

Re: Token ring VLAN and Subnet

Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

91
Views
0
Helpful
1
Replies