Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

traffic limiting on C6K5 CatOS

I have been trying to set a limit on the traffic that can flow out or into a fast Ethernet port on a Cisco 6500 running Cat OS.

I have tried the policer aggregate command, I enabled QOS globally and specified ACL and ACE, and then linked it to a port, ie. 9/4.

But have not had any luck what so ever.

I have been trying to limit the data transfer, regardless of what kind of traffic to 2MB/sec.

Can anyone please help me out on this one?

These are the commands that I used:

set qos enable

set qos policer aggregate Traffic-Test rate 2000 burst 1 drop

set qos acl ip Traffic_Shapping dscp 0 aggregate Traffic-Test ip any any

commit qos acl all

set qos acl map Traffic_Shapping 9/4

I am not running any Quality of Service stuff just regular traffic.

Thanks.

1 REPLY
New Member

Re: traffic limiting on C6K5 CatOS

Currently only Ingress Policing is possible.

What sup and PFC and sotware version ?

The commands should be fine. is 9/4 set to default port-based qos.

what does the output of the sh qos statistics l3stats say.

if you using sup2/pfc2 you may be able to see the stats on per policer basis.

108
Views
0
Helpful
1
Replies
CreatePlease login to create content