I am trying to traffic-shape on int fddi2/0 to limit traffic to 15 MB. The line I am using is:
traffic-shape rate 15000000 15000000 1000
Traffic passes thru until traffic shaping kicks in. Once it does I cannot ping my interface from the outside, but yet via the console port is says it is up. I have to issue a shutdown and then a no shutdown to bring the interface back up. Any ideas anyone? I am down to my last few strands of hair right now.
The traffic shaping should have no effect on the interface being up or down. Try removing traffic shaping to see if you can ping the interface. Make sure that the access-list you have set up allow ICMP traffic as well.
We have 3 identical switches configured by someone else and would like to claim some of the Gigabit ports(G1/G2/G3/G4) for use on servers. When we try to change the wiring and configuration, we run in to connectivity issues. Attached is a des...
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...