Traffic Shaping on a 2600 router (IOS ver 12.2.31)
I have configured traffic shaping on a Fastethernet subinterface as follows;
traffic-shape rate 256000 7936 7936 1000
After reviewing the management graphs it looks as though the Traffic Shaping is not working as the graph shows a utilization of 800%. Is there a known reason for this and is there a way I can check on the router. I have ran the show commands but nothing is obvious as to the reason for this. The router is a replacement for a 1721. The same config has been applied. This started happening when the routers were changed.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...