Traffic Shaping on a 2600 router (IOS ver 12.2.31)

[spencedavid21]

I have configured traffic shaping on a Fastethernet subinterface as follows;

f0/0.1

traffic-shape rate 256000 7936 7936 1000

After reviewing the management graphs it looks as though the Traffic Shaping is not working as the graph shows a utilization of 800%. Is there a known reason for this and is there a way I can check on the router. I have ran the show commands but nothing is obvious as to the reason for this. The router is a replacement for a 1721. The same config has been applied. This started happening when the routers were changed.

[apf3885]

This is a very vague question, but you may need to add a bandwidth statement to your interface for your application to correctly interpret the utilization.