Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Traffic shaping on a port level

How can I send traffic thats inbound on the LAN side to a specific PVC on the Frame Relay WAN side? Specificly ftp control traffic. I want the ftp control port traffic to use only one PVC while all other traffic is equal cost load balanced across both PVC's with EIGRP.

  • Other Network Infrastructure Subjects
1 REPLY
New Member

Re: Traffic shaping on a port level

You can use policy routing... which is source based routing.

You can force traffic from a certain source subnet (including ports) matching any destination (including ports) to go out any direction you want.

I recommend using policy routing as a temporary fix until you can find a permanent solution. Try to manipulate normal routing first before resorting to policy routing.

109
Views
0
Helpful
1
Replies
This widget could not be displayed.