Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Traffic shaping

i have next situation-

Router 2610

!

class-map match-all tcp

match access-group name tcp

class-map match-all ftpserver

match access-group name ftpserver

class-map match-all webserver

match access-group name webserver

!

!

policy-map internet

class webserver

bandwidth 64

class ftpserver

bandwidth 128

shape average 256000

class tcp

bandwidth 320

class class-default

fair-queue

!

!

interface Serial0/0

bandwidth 512

no ip address

max-reserved-bandwidth 100

encapsulation frame-relay

no ip route-cache

no ip mroute-cache

load-interval 30

frame-relay ip rtp header-compression

!

interface Serial0/0.1 multipoint

frame-relay class INTERNET

frame-relay map ip A.B.C.D 100 CISCO

!

!

map-class frame-relay INTERNET

no frame-relay adaptive-shaping

frame-relay cir 512000

frame-relay mincir 512000

service-policy output internet

!

=========================

2610(config)#int s0/0

2610(config-if)#frame-relay traffic-shaping

Traffic shaping not enabled due to invalid policy in map-class INTERNET

Why i can't enable that policy?

3 REPLIES
New Member

Re: Traffic shaping

GTS : shape command within a policymap not supported over FR VCs

Router(config-subif)#frame-relay interface-dlci 100

Removing invalid map-class from subinterface

New Member

Re: Traffic shaping

But if i remove line

shape average 256000

from policy-map internet class ftpserver

i can enable policy

New Member

Re: Traffic shaping

Gday again,

If you remove the frame-relay map ip A.B.C.D 100 CISCO

from interface Serial0/0.1 multipoint

Leave the rest as it was originally then apply the policy to serial0/0.1 what happens ?

Allan

114
Views
0
Helpful
3
Replies
CreatePlease to create content