Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Traffic throughput

Is there a way to view the amount of traffic that has transversed an interface? in either kb/mb/gb?

the only option I see is 'show ip traffic'...

3 REPLIES
Silver

Re: Traffic throughput

a sh int serial x will show you the input and output packets as well as the 5 minute input output rate , you can change the rare by using the load-interval x , x equals the number of seconds.

you can clear the counters to get a new snapshot.

New Member

Re: Traffic throughput

The show interface commands shows me the 40 % utilization (around 95/255) and also CiscoWorks shows me the same results, the load-interval was changed to 30 sec.

New Member

Re: Traffic throughput

Is the 5 minute input\output rate an average over 5 minutes or the total throughput in 5 minutes. I notice it says in k/sec so i assume its a 5 minute average.

thanks

172
Views
0
Helpful
3
Replies
CreatePlease to create content