Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

transmit-interface

can anyone explain more on command "transmit-interface" under interface mode?

  • Other Network Infrastructure Subjects
1 REPLY
Anonymous
N/A

Re: transmit-interface

From CCO:

You can configure simplex Ethernet interfaces. This feature is useful for setting up dynamic IP routing over a simplex circuit (a circuit that receives only or sends only). When a route is learned on a receive-only interface, the interface designated as the source of the route is converted to the interface you specify. When packets

are routed out this specified interface, they are sent to the IP address of the source of the routing update.

So, for example, we have this:

int e 0

transmit-interface ether 1

Any routes that are learned from ethernet 0

(a receive only interface) will show up

in the routing table as pointing to

ethernet 1; all traffic that is destined

for the remote routes learned from

ethernet 0 will be sent out with the

next hop address that was included in

the route update, but the packet transmission

will be on ethernet 1.

2265
Views
0
Helpful
1
Replies