Is it possible to put tresholds on catalyst utp ports so an alert will be sent when it generates a certain amount of errors in a period of time. Can Cisco works 2000 play a role in this or is there third party software which can do this tasks.
Using most any network managment software you can monitor values via SNMP. You should be able to monitor any value on the catalyst switch using Cisco Works 2000. You can also try a demo version of What's Up Gold. You can set up alerts based on SNMP vlaues. www.ipswitch.com. Although you can set the switch to send SNMP traps, keep in mind you set up thresholds/alerts via the network managment software not the switch itself. Hope that helps.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...