Txload/rxload is a good place to start assuming the configured/default interface bandwidth is set to reflect the actual bandwidth of the link. It's based on a scale of 255. Let's say if txload is 127/255 on a ethernet (10mbps) interface, the actual txload is 5mbps.
Other thing that might be helpful is the 5 minute input rate/output rate. This will give you the average input/output rate for a period of 5 mins. This interval can be modified with the command 'load-interval' and the least you can set it to is 30 seconds and that would give you a more accurate picture.
Yes, high number of output drops indicates the interface is unable to transmit as fast as the packets are handed over to it. This could be due to congestion on the WAN, ingress interface bandwidth much higher (eg. 10mb - 1.55mbps) than the egress interface causing a bottleneck or misconfigured shaping on the router etc. One way to alleviate this is to use some kind of QOS congestion management technique.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.