Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

troubleshooting e1 pri

Hi,

I have a 2600 router(remote end) with e1 (pri) connected to nortel PBX .dial plan for analog phones connected to PBX is 3XXX. At the local end,I have a 2600 router with FXS module to which I have connected an analog phone(Ext 2001).I have configured dial-peer 2... on the remote end router pointing to local router.

Problem-

From ext 2001,I am able to reach 3001 by dialing "3001".but if I want to reach 2001 from 3001,I have to dial 2 first ,wait for 4 sec after which I get a dial tone , than press 2001 after which the call gets established.

How can I reach directly by just pressing "2001".

PBX is confiured to direct all the calls begining with 2 to router e1 port.

output of debug vtsp dsp shows dialed digits as 2001( I am not able to see "2" pressed initially to get dial tone).

Where could be the problem?

Regds

Kiran

1 REPLY
VIP Purple

Re: troubleshooting e1 pri

Hello Kiran,

on the remote end you could configure number expansion:

num-exp 2001 22001

but I am not sure how to insert the 4-second timeout after the first digit...one of the timing commands might work.

HTH,

GP

604
Views
0
Helpful
1
Replies
CreatePlease to create content