Hi,
I have a 2600 router(remote end) with e1 (pri) connected to nortel PBX .dial plan for analog phones connected to PBX is 3XXX. At the local end,I have a 2600 router with FXS module to which I have connected an analog phone(Ext 2001).I have configured dial-peer 2... on the remote end router pointing to local router.
Problem-
From ext 2001,I am able to reach 3001 by dialing "3001".but if I want to reach 2001 from 3001,I have to dial 2 first ,wait for 4 sec after which I get a dial tone , than press 2001 after which the call gets established.
How can I reach directly by just pressing "2001".
PBX is confiured to direct all the calls begining with 2 to router e1 port.
output of debug vtsp dsp shows dialed digits as 2001( I am not able to see "2" pressed initially to get dial tone).
Where could be the problem?
Regds
Kiran