12-23-2003 07:47 AM - edited 03-02-2019 12:31 PM
I have a CAT6509 that is showing, what seems to be, and enormous amount of PHYSICAL ERRORS and RUNTS. I can see this by doing a show port. Does anyone have suggestions or experience troubleshooting these errors? My first thougth was DUPLEX SPEED mismatch, but I have verified the first few are set properly.
12-23-2003 10:27 AM
12-23-2003 11:11 AM
Thanks, but I cannot reach that link. It says I am not a registered user (even though I'm logged into CCO). Typical
12-23-2003 02:04 PM
HOw many ports experiencing these errors? Could you send a "sh port" output? Is there anything common for erronous ports (in the same module, connected to same type of hosts)?
12-24-2003 07:53 AM
Are These errors input or output?
If is Input then there are a lot of noise near to switch
If Is Output the is possible that the module or the port is bad.
You can execute a test for the module.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: