08-21-2003 01:46 AM - edited 03-02-2019 09:46 AM
I have a foundry BigIron layer 3 switch and a cisco Catalyst 3500XL. and I defined a trunk dotq1 on the cisco switch and a trunk port on foundry switch, But it is not working. I cannot ping from the cisco switch to any of the vlans
08-22-2003 03:09 AM
I'm also looking for an answer since we couldn't use dot1q between a Cisco 6509 and a Foundry ServerIron !
08-26-2003 05:52 AM
regarding the ServerIron, you shouldn't configure a trunk between the Catalyst and the SI, because the SI works on layer 2 and 4-7 not layer 3. Your design should be like this, put the ServerIron in any of the VLANs and assign the SI with an IP address and then connect the SI with Catalyst with one of that Vlan ports. if u need any help regarding configuring the SI tell me
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide