I have two Switches IOS Cisco 2924 one with IOS (C2900XL-H-M), Version 11.2(8)SA4 and other with IOS (C2900XL-H-M), Version 11.2(8)SA5, when I try to configure trunk, the command switchport mode doesn't have the subcommand trunk, just have the subcommand access or multi, how can I configure trunk ?
Just to inform you cat2924xl with 4MB flash doesn`t support trunking. so you will not be able to able create trunks on 4 MB catalysts. I`m very sure that your switches have 4 MB flash, let me know if you have different switches.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...