These switches are connected in a trunk ring by 2 GE interfaces on every switch.
All the same VLAN are defined on all the switches.
I need to analyze traffic and i need to set VSPAN sessions. WIll the ring give problems? that is, if traffic from one server, linked to one of the switch 6513, goes on the trunk and it reaches the MSFC before going on the second switch 6513, where it has been defined the SPAN destination port for the VSPAN session, will i be able to monitor anyway this traffic?
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...