I am attempting to set up a trunk link between a 3550-12T and a 2950T-24 and seem to be having some troubles. I am trying to connect the trunk link between one of the 10/100/1000BT ports on the 2950 and the 10/100/1000BT port on the 3550. However when I connect the two (whether using straight through or crossover cables) I cannot get a physical link. I have tried everything from changing the trunk modes, speed/duplex and have tried different ports. The strange thing is that the link comes up just fine if I connect the cable to one of the 10/100 ports on the 2950 rather than the 10/100/1000. Could this possibly be a software problem or a hardware incompatibility? I am running 12.1(6)EA2c on the 2950 and 12.1(8)EA1c on the 3550. Any help is greatly appreciated. Thanks!
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.