Can these 2 devices support gig etherchannelling? I need to trunk 3 gig ethernet between 7613 and 12416. GSR does support portchannels but to allow trunking dot1q must be configured. If any one is doing this please print a sample config.
I can trunk between 2 cisco 7613's not a problem. My issue is I have a 7613 and a 12416 at same location and I need to trunk them. Not sure if this will work, I can't find any documentation to support creating L2 interfaces on GSR so I can trunk them.
Any one with any White Papper, or experience please reply before I open a TAC case.
As far as I know the GSR will be able to support dot1q trunk. So, you will need to channel the gig interfaces and create a L3 port-channel interface and sub-interface the port-channel with dot1q encapsulation.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...