10-02-2002 10:23 AM - edited 03-02-2019 01:48 AM
Hi all,
I have a 6509 switch which I use and I wanted to expand more ports off that 6509. I can use a hub and do an uplink from it but I have a spare 5502 cat on hand so I want to use it to expand more ports.
How would you configure the 6509 and 5502 switch? trunking or uplink?
I have more than one vlans on the 6509.
Thanks,
Steve
10-02-2002 10:38 AM
If you want more than one vlan per physical cable, you will have to using trunking. Command is "set trunk x/x .... ". See link on how to trunk: http://www.cisco.com/warp/public/473/27.html . If you wanted to waste ports you could use one cable per vlan.
Hope it helps.
Steve
10-02-2002 11:07 AM
Thanks.
Do I use a cross over cable to connect from switch 1 trunk port to switch 2 trunk port?
Steve
10-02-2002 11:43 AM
Yes, switch to switch cables are cross over.
Steve
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: