Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

TUNNEL for Standard Sync Serial Data Needed

Need help or a good reference point to connect a 530 serial port on one Cisco to another serial port on a different cisco and have them linked together transparently via IP. I am gussing I need to build a tunnel between the two router, but after that I am unsure of the exact configurations needed. The end devices will be DTE Muxes with a 530 interface. I will use the Timming from the cisco's to provide timing and clocking to the muxes.

Thank you,

Rick

2 REPLIES
New Member

Re: TUNNEL for Standard Sync Serial Data Needed

R1 s0-------s0 R2

R1 s0 192.168.1.1/24

R2 s0 192.168.1.2/24

R1

int tunnel 0

ip addr 192.168.1.3 255.255.255.0

tunn source se 0

tunn desti 192.168.1.2

R2 same as above

New Member

Re: TUNNEL for Standard Sync Serial Data Needed

Will I have to use DCE cables from the router to the muxes and config the Bandwidth and such on the router interface to provide the needed timing and clock or will this act as a transparent tunnel between the 2 serial ports.

Thank you again,

Rick

146
Views
3
Helpful
2
Replies