Tunnel interface bandwith

[mkallasch]

Hello,

The "show int tunnel 1" command shows the following output:

Tunnel1 is up, line protocol is up

Hardware is Tunnel

Internet address is xxx.xxx.xxx.xxx 255.255.255.252

MTU 1514 bytes, BW 9 Kbit, DLY 500000 usec,

reliability 255/255, txload 1/255, rxload 154/255

....

My question now. Is the BW parameter (9 KBit) for the routing process (routing table) only or is there another meaning, a kind of traffic shaping e.g. ?

Is the rxload 154/255 a problem ?

Thanks

Mathias

[ciscomoderator]

Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.