Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Tunnel interface bandwith

Hello,

The "show int tunnel 1" command shows the following output:

Tunnel1 is up, line protocol is up

Hardware is Tunnel

Internet address is xxx.xxx.xxx.xxx 255.255.255.252

MTU 1514 bytes, BW 9 Kbit, DLY 500000 usec,

reliability 255/255, txload 1/255, rxload 154/255

....

My question now. Is the BW parameter (9 KBit) for the routing process (routing table) only or is there another meaning, a kind of traffic shaping e.g. ?

Is the rxload 154/255 a problem ?

Thanks

Mathias

1 REPLY

Re: Tunnel interface bandwith

Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

101
Views
0
Helpful
1
Replies