Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

two equal cost links

hi all,

can anyone pls help me out..

i am having two equal cost e1 links (leased line 2 mbps) to other center , so now can i give any command in the router to make it vertually 4 mbps so as to fast data transfer,,,,,,i am using RIP V1 as my routing protocol...

pls help me...

regds,

mangesh

2 REPLIES
Bronze

Re: two equal cost links

There is no way to make 2 T1 links operate at 4 mbps. The end to end bandwidth will still be 2 mbps however, by default, the router will load share over, up to 4, equal cost paths. This will be on a per session, rather than on a per packet, basis however, so you may not see equal utilisation.

New Member

Re: two equal cost links

hi mangesh,

i think you can use a 'interface multilink' to bundle the two links togehter,

when you are using ppp on the wan links.

on this configuration you are also independent from the routing protocol you are using.

have a look at this link or try search from interface multilink in cco:

http://www.cisco.com/en/US/tech/tk713/tk584/technologies_configuration_example09186a00800a5efa.shtml

hope this helps,

udo

153
Views
0
Helpful
2
Replies
CreatePlease login to create content