12-07-2002 12:12 PM - edited 03-02-2019 03:26 AM
hi all,
can anyone pls help me out..
i am having two equal cost e1 links (leased line 2 mbps) to other center , so now can i give any command in the router to make it vertually 4 mbps so as to fast data transfer,,,,,,i am using RIP V1 as my routing protocol...
pls help me...
regds,
mangesh
12-08-2002 05:33 PM
There is no way to make 2 T1 links operate at 4 mbps. The end to end bandwidth will still be 2 mbps however, by default, the router will load share over, up to 4, equal cost paths. This will be on a per session, rather than on a per packet, basis however, so you may not see equal utilisation.
12-09-2002 03:47 AM
hi mangesh,
i think you can use a 'interface multilink' to bundle the two links togehter,
when you are using ppp on the wan links.
on this configuration you are also independent from the routing protocol you are using.
have a look at this link or try search from interface multilink in cco:
http://www.cisco.com/en/US/tech/tk713/tk584/technologies_configuration_example09186a00800a5efa.shtml
hope this helps,
udo
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: