I upgraded on 2610 with a different IOS. However, I did not erase the first flash so it now has both files in flash. How do I get it to use the second flash IOS file and get rid of the first IOS file? I prefer not to erase flash and re-TFTP if I don't have to.
Using the boot system flash command, you can force the router to boot on the second image. Regarding the removal of the old file, it is not possible on the 2600 to selectively remove a file from a flash partition. You have to erase the whole content.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...