Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

two quad E1/PRI in one AS5300

we want to use two Quad E1/PRI into one AS5300. the software is IOS Version 12.0 (7). the first one is build in slot 0 and we want to put in the second one in Slot 2. the slot 1 is occupied by Mica-Modems.

at the reboot after the build up we see the following massage on the console line.

00:00:06: Error: This system doesn't allow more than1 T1/E1/PRI card

is this a software (release), hardware (firmware) problem or is it impossible to use two interfaces in one AS

1 REPLY
Anonymous
N/A

Re: two quad E1/PRI in one AS5300

AS5300 cannot have more than 1 quad card installed on its chassis.

You might consider using an octal E1/PRI card instead.

111
Views
0
Helpful
1
Replies
CreatePlease to create content