Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

txload/rxload

All:

Are these real time counters? I understand that they measure outbound and inbound utilization, expressed as fracs of 255.

DLR1#sh int s1/0:0 | i load

reliability 255/255, txload 1/255, rxload 1/255

However, I don't ever see them changing.

Am I correct in saying my utilization for the load interval would be 12.5%

??

tia

S

2 REPLIES

Re: txload/rxload

255/255 is 100% link utilization. In your case 1/255 is almost 0% (0.39% to be precise).

Cheers

New Member

Re: txload/rxload

U can give an extended ping to the remote serial interface to see if the load varies. Load interval is the interface statistics data for every 5 minutes(by default). You can change it to 30 second load interval by specifying "loadinterval 30" under the config-if mode

332
Views
0
Helpful
2
Replies