Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

UBR905 Question

I need some information about the 905 cable routers.

I am doing an install for a customer and Comcast is putting a ubr905 cable router/modem in with a static ip address.

Will it be possible to put another router(an 831 for example) behind that and assign the static ip to the 831? If so do i need a specific configuration on the 905, like putting into a bridge mode or does the 905 come already setup to be able to do this?

Any info or a push in the right direction would be great.

Tony

1 REPLY
Bronze

Re: UBR905 Question

You can use uBR 905 in a bridging mode , refer the following link :

http://www.cisco.com/en/US/tech/tk86/tk89/technologies_configuration_example09186a0080093faf.shtml

102
Views
0
Helpful
1
Replies
CreatePlease to create content