Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

uBR924- ACL problem

I would like to integrate an uBR924 into my private network at home.Nothing fancy,just uBR924 configured as a plain old cable-modem!! I already have a 1720 RTR for my routing.

Problem is, whenever I try to configure the uBR924 for bridging, during boot-up some configuration file automatically creates an ACL and applies it to the uBR924 interface. Hence, preventing traffic from being passed though the uBR924.

To get the uBR924 to work, I go into the IOS and manually remove the ACL. I have to do this after each re-boot. My question, does anyone know of a way to stop this ACL from being automatically being added? Any suggestions would be greatly appreciated.

2 REPLIES
Bronze

Re: uBR924- ACL problem

After removing the ACL from the configuration, enter the command "copy run start" to update the configuration that loads upon power-up.

HTH

Mark

New Member

Re: uBR924- ACL problem

Mark,

Thanks but,thats what I'm trying to say,"copying my Run config to Startup.config doesn't make a difference! That DAMN configuration file automatically appends the startup config and keeps re-appling the ACL every time I boot-up. Does anyone know how to get around this auto-configuration??

83
Views
0
Helpful
2
Replies