Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

UDLD on Cisco Catalyst 4006

Hi! If i enable udld globally, will it take effect on all the modules as well?

I tried to enable udld on a few module's ports, but the system prompted me something like... you must enable globally first.

Any advise?

Another question is that when i issue a command

set trunk 2/1 nonegotiate dot1q

1025-4094, will also be displayed in that interface when i run the command show conf. Do i have to clear trunk for 1025-4094? My understand is that by default there's only 1-1005.

Thanks.

  • Other Network Infrastructure Subjects
3 REPLIES
Purple

Re: UDLD on Cisco Catalyst 4006

I believe you have to enable globally first then disable any ports you don't want it on . Vlans 1025-4094 are extended vlans and must be manually cleared off the trunk if you don't want them running across the trunk...

Bronze

Re: UDLD on Cisco Catalyst 4006

My understanding is that when you enable it "globally" you are really enabling it on all fiber-optic links within the chassis but not on any others; copper links must be individually configured if you want it on them also. (it's a substantially lower probability that a copper link will be or can become unidirectional)

I believe whether you're in VTP transparent mode or not may have some impact on what the default VLAN range is.

John

Silver

Re: UDLD on Cisco Catalyst 4006

When you enable UDLD globaly the default is UDLD will be enabled on all fiber based ports and is disabled on all copper based ports. You can then disable (or enable) it on the ports that you wish.

Also, just as an FYI, if the remote end switch port does not have UDLD enabled, then UDLD will not function and it will not disable the port.

With regard to your second question, according to the documentation, the default is 1-1005, 1025-4094.

112
Views
0
Helpful
3
Replies