Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Un able to send or receive packets

I am un able to send or receive packets across my WAN. Surprisingly the statics of the show interface command of routers on both ends of the WAN shows something like this.

Serial1/3 is up, line protocol is up

Hardware is CD2430 in sync mode

Description: Connecting NTCHEU CCC

Internet address is 192.168.40.6/24

MTU 1500 bytes, BW 128 Kbit, DLY 20000 usec, rely 135/255, load 1/255

Encapsulation HDLC, loopback not set, keepalive set (10 sec)

Last input 00:00:00, output 00:00:00, output hang 5d22h

Last clearing of "show interface" counters never

Input queue: 0/75/0 (size/max/drops); Total output drops: 699

Queueing strategy: weighted fair

Output queue: 0/1000/64/679 (size/max total/threshold/drops)

Conversations 0/50/256 (active/max active/max total)

Reserved Conversations 0/0 (allocated/max allocated)

5 minute input rate 0 bits/sec, 0 packets/sec

5 minute output rate 0 bits/sec, 0 packets/sec

255018 packets input, 16955412 bytes, 0 no buffer

Received 106160 broadcasts, 0 runts, 3 giants, 0 throttles

5932220 input errors, 3520772 CRC, 0 frame, 0 overrun, 0 ignored, 2411421 abort

366882 packets output, 112003269 bytes, 0 underruns

0 output errors, 0 collisions, 140948 interface resets

0 output buffer failures, 0 output buffers swapped out

222 carrier transitions

DCD=up DSR=up DTR=up RTS=up CTS=up

On the other end of the WAN the Serial interface of the router has 192.168.30.22 as its ip address and interface statics show that the line protocol is up as well. The line I am using is a 14.4k inetrfaced by codex modems.

Would anyone know what could be causing this surprising scenario?

Is high CRC(3520772 CRC) something to do with the line, router or the modem?

3 REPLIES
New Member

Re: Un able to send or receive packets

That many line errors certainly is not good and I would get it checked out, but it looks to me like your WAN interface addresses are on different subnets.

Regards

John

New Member

Re: Un able to send or receive packets

Please check the other end encapsulation also... if it is different other that hdlc the above error occurs...

New Member

Re: Un able to send or receive packets

Hi

The CRC is definetely a factor to be considered as this would be a factor for consideration for the Link to be UP.

The other factor is the type of encapsulation that is used on both the ends of the N/W.Please do also check on the type of the network along with the network mask.

The high rates of CRC will essentially imply the loss of packets and try using the clear counters command in the en prompt.

Thanks

Vatsan

105
Views
0
Helpful
3
Replies
CreatePlease to create content