Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

Unable to access any http services from AS5350

My question pertains to accessing http when dialed into AS5350. I have a configuration that allows me to connect from our private IP range to our public. I can telnet, and ftp to outside resources, but am unable to gain any web access whatsoever. I am uplinked to our PIX firewall, which is open on the specified port to not block anything. Any configuration options that ring a bell to anyone that should be configured on the AS5350 to allow me to access http sites? I can ping up to the outbound access point for Internet access, which disallows ICMP replies as well. I am also able to receive nslookup replies from our DNS servers and am able to obtain an IP address fine as well.

Any help is greatly appreciated!

Thanks in advance...

2 REPLIES
Community Member

Re: Unable to access any http services from AS5350

Check for any access-lists on the AS which may be denying HTTP

Community Member

Re: Unable to access any http services from AS5350

There are no ACL's applied to our AS5350. Thanks though...

97
Views
0
Helpful
2
Replies
CreatePlease to create content