Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Unable to access FWSM via session slot command

Hello,

I'm running FWSM (stdby) on Cat6500.

I'm unable to access FWSM console via

Router# session slot 3 processor 1

command.

6500#session slot 3 processor 1
The default escape character is Ctrl-^, then x.
You can also type 'exit' at the remote prompt to end the session
Trying 127.0.0.31 ...
% Connection timed out; remote host not responding

I've tried

hw-module module 3 reset cf:1

without any resoult.

Do you have any idea how to access FWSM?

Regards

R.

Everyone's tags (2)
1 REPLY

Re: Unable to access FWSM via session slot command

Hello,

I'm running FWSM (stdby) on Cat6500.

I'm unable to access FWSM console via

Router# session slot 3 processor 1

command.

6500#session slot 3 processor 1
The default escape character is Ctrl-^, then x.
You can also type 'exit' at the remote prompt to end the session
Trying 127.0.0.31 ...
% Connection timed out; remote host not responding

I've tried

hw-module module 3 reset cf:1

without any resoult.

Do you have any idea how to access FWSM?

Regards

R.

Hi R,

Check out the below link for taking session in FWSM in cat and as well as in cisco ios.

http://www.cisco.com/en/US/docs/security/fwsm/fwsm22/configuration/guide/sysmgmt.html

Hope to Help !!

Ganesh.H

Remember to rate the helpful post

6537
Views
5
Helpful
1
Replies
CreatePlease to create content