I just uploaded a new IOS into a router abd tried to boot from it but it was not successfull as the router keep on rebooting as saying flash:xxxxx file boot not accessible.I could'nt get into the configuration mode.
Are your sure you unloaded the correct IOS. Can you break into Rommon and boot the router from there with the new image or a previous ios. More than likely you will have to go into rommon and delete the image and load a new image via xmodem
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...