02-21-2003 06:35 AM - edited 03-02-2019 05:16 AM
hi
i can't change clockrate on 2651 (12.2.7r) on NM2T
with error message
(config)#int s1/0
(config-if)#no clock rate
FECPM PM doesn't support clock rate 0
is it supported or do i something wrong ?
thanks
JYP
02-21-2003 06:48 AM
JYP,
Rather than trying "no clock rate" and making it null/0 have you tried "clock rate
Hope this helps,
Don
02-21-2003 06:52 AM
Don
thanks for you reply, but i want to remove clockrate because
clockrate is provided my Modem so i need to remove from router
side (i did on other serial interface without this issue)
JYP
02-21-2003 07:00 AM
JYP,
If the interface is a DCE then you'll not be able to remove this. This could be as simple as changing to a DTE cable that connects your interface. I believe a "show controllers serial
Hope this helps,
Don
02-21-2003 07:05 AM
Don
should i enter no DCE to remove DCE configuration
on interface ?
02-21-2003 07:13 AM
If there is a DCE configuration on the interface then yes. Sometimes the cable type that is connected to the interface will determine if this is DCE or DTE. (check the cable a lot of times it says it right on there).
Hope this helps you,
Don
02-21-2003 08:05 AM
did you change your clock source to line
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide