Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Unable to communicate between switches

Hi,

I have two switches (3524XL) configured in cluster mode (one command switch and another member switch). The vlans connected to command switch are able to communicate to core switch (6509). But vlans configured in member switch are not able to do so. Gig0/1 of both switches are used for clustering. Gig0/2 of command switch is connected to core switch. All these ports are on ISL encap. VTP mode is transparent.

Pls suggest,

Regards,

Silju G Pillai

1 REPLY

Re: Unable to communicate between switches

Often times complex troubleshooting issues are best addressed in an interactive session with one of our trained technical assistance engineers. While other forum users may be able to help, it’s often difficult to do so for this type of issue.

To utilize the resources at our Technical Assistance Center, please visit http://www.cisco.com/tac and to open a case with one of our TAC engineers, visit http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

104
Views
0
Helpful
1
Replies
CreatePlease to create content