Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

unable to config 2950 switch

Have a switch someone messed with and not when I start switch up and and telnet in via console cable I receive this message and a "switch" prompt.

What next?

C2950 Boot Loader (CALHOUN-HBOOT-M) Version 12.0(5.3)WC(1), MAINTENANCE INTERIM

SOFTWARE

Compiled Mon 30-Apr-01 07:56 by devgoyal

WS-C2950-24 starting...

Base ethernet MAC Address: 00:08:20:5b:52:80

Xmodem file system is available.

Initializing Flash...

flashfs[0]: 1 files, 1 directories

flashfs[0]: 0 orphaned files, 0 orphaned directories

flashfs[0]: Total bytes: 7741440

flashfs[0]: Bytes used: 1536

flashfs[0]: Bytes available: 7739904

flashfs[0]: flashfs fsck took 4 seconds.

...done initializing flash.

Boot Sector Filesystem (bs:) installed, fsid: 3

Parameter Block Filesystem (pb:) installed, fsid: 4

The system is unable to boot automatically because there

are no bootable files to boot.

switch:

1 REPLY
Cisco Employee

Re: unable to config 2950 switch

If you do not have any files in flash, use the recovery steps as in the following tech tip

http://www.cisco.com/warp/public/473/192.html

124
Views
0
Helpful
1
Replies
CreatePlease to create content