Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Unable to Load NAM Module - showing PwrDown

I have a NAM Module installed in a Cat 6509 and I am unable to bring it online.

The Show Mod command shows that the module is in the PwrDown status.

If I reset the module by reseating it in the chassis I get a logg message saying:

%C6KPWR-SP-4-DISABLED: power to module in slot xx set to off (Module Failed SCP dnld).

Does this mean that the module has a fault or is there a way to recover?

PS - I have tried reloading the whole switch and it makes no difference.

Thanks

9 REPLIES
Purple

Re: Unable to Load NAM Module - showing PwrDown

If this is hybrid did you try the "set module power up " command ?

New Member

Re: Unable to Load NAM Module - showing PwrDown

Hi Glen,

The 6500 is running IOS, do you know if there is an equivalent command?

Purple

Re: Unable to Load NAM Module - showing PwrDown

You can try hw-module module X reset . X is your module number . I doubt there is a problem with the nam just sounds like the mod is powered down.

New Member

Re: Unable to Load NAM Module - showing PwrDown

I tried this and it didn't make any difference.

Anybody have any other ideas?

New Member

Re: Unable to Load NAM Module - showing PwrDown

Hi,

Can you verify if there is enough power to support the module? Just a guess.

Vilas

Anonymous
N/A

Re: Unable to Load NAM Module - showing PwrDown

Anonymous
N/A

Re: Unable to Load NAM Module - showing PwrDown

Anonymous
N/A

Re: Unable to Load NAM Module - showing PwrDown

New Member

Re: Unable to Load NAM Module - showing PwrDown

Check your catos version and check to see the minimal required code to run NAM module. It probably powered down because the SUP did not recognized it.

416
Views
0
Helpful
9
Replies
CreatePlease to create content