I have two Cicso 760's connected through an ISDN, a remote and host. From the host location, I can ping the host and remote, as well as telnet them both. At the remote location, I cannot ping the 760 there, even though it is connected and is successfully passing IPX traffic to the host. It is set to be a node and is connected to a hub. All other connections check out OK. Thanks
We'd need more information than this, most likely. You'll need to at least look at the routing tables and such to see what they are doing, and also make certain ip classless is turned on (it's the default for all newer code).
This document gives several answers on frequently asked questions for PFRv3 channel state behavior.
Q1: What are all the channel operational states from a BR (border role) perspective and what are the rules/conditions to be in each st...
The need was to reach an host inside a LAN through a VPN connection managed by the LAN gateway (Cisco 1921).
The LAN gateway performs NAT and there was a dedicate nat rule for the host i wanted to reach through VPN.
I couldn't connect to the hos...
We have 3 identical switches configured by someone else and would like to claim some of the Gigabit ports(G1/G2/G3/G4) for use on servers. When we try to change the wiring and configuration, we run in to connectivity issues. Attached is a des...