unable to ping to isp's router with the below config
i have configured cisco 1751 router with the config below.but iam unable to connect to the internet.even i have checked with the isp abt the line and it is working fine and i also checked with zyxcel router,iam getting connected to isp.i want to know wether there is any problem with config.iam able to ping to e0 and s0 of the cisco router frm any node but not to the isp.can any one help me fast.
Using 854 out of 29688 bytes
service timestamps debug datetime msec
service timestamps log datetime msec
no service password-encryption
enable secret 5 $1$0mrV$uzBV.ivrbAK9hzuOZJli8/
enable password hudson
memory-size iomem 25
no ip routing
ip name-server 184.108.40.206
ip address 192.168.1.5 255.255.255.0 secondary
ip address 218.x.x.x 255.255.255.x
ip nat inside
no ip route-cache
ip unnumbered FastEthernet0/0
ip nat outside
no ip route-cache
ip nat inside source list 1 interface FastEthernet0/0 overload
Re: unable to ping to isp's router with the below config
Check for the default route and it shud point the serial interface..If your serial interface has no IP configured and unnumbered mapping to FE address, what is the IP configured at ISP end towards ur link??
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.