Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Understanding Access-List ????

Hi All.

I have just one point to understand in access list.

I have a client place where I have installed a 801 for LAN connect.

The requirement being that the users from outside ie the internet.

I gave the access list as follows.

interface BRI0

no ip address

ip access-group 110 in

no ip directed-broadcast

encapsulation ppp

dialer rotary-group 1

isdn switch-type basic-net3

no cdp enable

..... ( then the usual , dial sting and all )

access-list 110 deny icmp any host 195.129.229.95

access-list 110 deny ip any host 195.129.229.95

access-list 110 permit tcp any host 195.129.229.95 eq 1352

dialer-list 1 protocol ip permit

Well it is said that apply the access-list to the interace and then it willwork fine,

the problem: I am not able to ping to the Public IP , thats good.

If I log on to any 98 MC and go to start , Run , and type in \\195.129.229.95 . I get network not found.

But specifically if I log on to a windows 2000 system , server R professional, and do the same thing,I am prompted with a username and password dialogue box.Which I am very upset with.

Any Ideas how to resolve this.?

Thanx in advance.

Tauseef

Tauseef@cadgulf.com

2 REPLIES

Re: Understanding Access-List ????

Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

New Member

Re: Understanding Access-List ????

Your Access list does not make sense to me. If you deny all IP , then the last permit will never fire, you will need to change the order. When you are prompted for the Winlogon - is it successfull?

When you attached the Access-list to the interface - how did you apply - in or out ?

Nick Haddock

110
Views
0
Helpful
2
Replies