I have a customer who is trying to setup various Class of Services by tagging packets with specific TOS bit patterns. Three CoS precedences are defined: flash, immediate, and routine. Although packets are being marked, the marked TOS fields do not appear to make any kind of sense. A sniffer capture shows the following:
flash ==> TOS 0xC0 ?? (expected 0x60)
immediate ==> TOS 0x08 ?? (expected 0x20)
routine ==> TOS 0x00 (OK)
Here is a snippet of the configuration. Any thoughts?
=======================================
version 12.1
....
boot system flash c2600-i-mz.121-14.bin
interface Serial0/0.2 point-to-point
....
ip policy route-map IPFR
...
access-list 5 permit 172.21.1.12
access-list 5 permit 172.21.1.15
access-list 5 permit 172.21.12.104
access-list 5 deny any
access-list 6 permit 172.21.12.104
access-list 6 deny any
access-list 10 permit 10.254.251.1
access-list 10 deny any log
access-list 150 permit tcp any eq telnet any
access-list 151 permit tcp any range ftp-data ftp any
access-list 152 permit tcp any eq www any
route-map IPFR permit 10
match ip address 150
set ip precedence flash
!
route-map IPFR permit 20
match ip address 151
set ip precedence immediate
!
route-map IPFR permit 30
match ip address 152
set ip precedence routine
